An air end failure can take your compressor down for weeks and cost a third or more of the price of a new machine to put right. The air end is the heart of a rotary screw compressor – two rotors…
Why Does My Air Compressor Short Cycle and How to Fix It
An air compressor that starts and stops every 30 seconds is the fastest way to shorten the life of its motor, contactor, and air end. Every start draws several times the full-load current, heating windings and hammering bearings. Air compressor short…
What Causes Low Pressure in a Screw Air Compressor?
Your tools stall at 6 bar when the compressor is set for 8 bar, and nobody in the plant can explain where the pressure went. Low pressure does not save energy – it forces the machine to run longer to make…
What Type of Oil Does a Rotary Screw Air Compressor Use?
Pour the wrong oil into a rotary screw air compressor and it foams, runs hot, and pushes oil into the air lines — contaminating product and forcing a high-temperature shutdown. The rotary screw air compressor oil type is not a small…
How Often Should You Change Screw Compressor Oil?
Run screw compressor oil past its service interval and it stops transferring heat. Discharge temperature climbs, the machine trips on high temperature, and production stops — while the airend wears a little more with every rotation. A single unplanned shutdown can…
Water-Cooled vs Air-Cooled Screw Air Compressors: How to Choose
Your cooling choice decides whether a screw air compressor survives its first hot season. In plants where ambient temperature climbs toward 45°C, an air-cooled unit loses cooling efficiency as the temperature difference between the machine and the surrounding air shrinks: discharge…
How to Ventilate an Air Compressor Room Properly
A compressor room that runs only a few degrees above specification can shorten the air end’s life and waste thousands of dollars in extra power every year. Poor air compressor room ventilation is the cause most plants overlook until a high-temperature…
How to Reduce Screw Air Compressor Noise in the Plant
An 85 dB compressor beside the production line is not background noise—it is a compliance, safety, and productivity problem. Screw air compressor noise reduction starts before acoustic foam, with machine design, installation, and duty-cycle choices. Why Screw Compressor Noise Becomes a…
How to Choose Between 7 Bar, 8 Bar, 10 Bar, and 13 Bar Screw Compressors
Buying an oversized-pressure air compressor means paying for pressure you never use. In many plants, every 1 kg/cm² of extra discharge pressure adds roughly 8% to compressor energy consumption, so a 10-bar unit doing an 8-bar job wastes power on every…
What Is ISO 8573-1 Air Quality and How to Read the Classes
A food plant scrapped a full production batch after oil aerosol in its compressed air tested at 1.8 mg/m³—just above the 1 mg/m³ ceiling for ISO 8573-1 compressed air quality Class 3 oil. The line was not the problem: the air…

















